Thinners for Teflon™ Coatings

Useful for lowering viscosity of Teflon™ coatings as well as keeping spray equipment clean and at optimal functioning.

Product Overview

Teflon™ thinners can be used for jobs where a lower viscosity is needed or for cleaning and maintaining your spray equipment. Thinners are a cost effective and simple way to clean spray guns by simply running thinner through the gun to clean out the coating from the passage. Well-maintained guns apply coatings with more efficiency and uniformity, as well as save time and money caused by equipment breakdowns. TN-8595 can be used for thinning and cleaning 420G, 958G, and 959G solvent-based products.

Uses

• Used to thin material for jobs that require low viscosity
• Easy clean up for certain solvent-based Teflon™ product lines

Aplication Processes
To clean with TN-8595/8718/8748:
Run some thinner through the gun through the spray equipment, just as if it were a coating.

To reduce material with TN-8595/8748:

• It is recommended that you do so in small increments, around 2-3% at a time, typically no more than 5-6% overall
• After adding thinner, the material should be re-incorporated by rolling.
• Rolling is the preferred re-incorporation method for liquid Teflon™ coatings.
• De-ionized water is recommended for reduction and and clean up of water-based products

Effects
The reduction of the liquid coatings will change the performance properties of the finished coating and the coating mixture while spraying. Thinning can have effects on:

• The appearance of the finished product
• The performance quality of the coating
• Increase the sensitivity to the required bake cycles
• Shorten the pot life of the material

Technicians should be aware of these potential changes when applying reduced material.

Marketing Material
To download this information in a PDF, click here.